FAQ 목록

Do you have any questions?

3D Printer 목록

  1. QHow do you do the post-processing for printed appliances?

    After printing out the aligners, the supports are removed, and the aligners are cured.(curing time, upward 5 minutes, downward 5 minutes). For other prints, you can cure them after 2 minutes of ultrasonic cleaning with ethanol or IPA.
  2. QWhich printer is better, SLA or DLP printer?

    Each has its pros and cons. In terms of output quality, if you want fast output, then go for a DLP. If you rather want a good quality then, an SLA is suitable.
  3. QThe printing did not go well (several lines in the printed appliance)

    Check if the output Vat has uneven surfaces. If that’s the case, then you need to even out the vat and If there’s still a problem after that, maybe the parameter is insufficient, or curing has been excessive.  You need to adjust the parameters again and try printing.
  4. QWhat printers can print Graphy materials?

    It can be used in SLA, DLP, and LCD 3D printers using light sources of 385nm to 405nm wavelength.
  5. QCan I put the material in the resin tank after printing?

    It is not a problem when used continuously, but if you do not print for a long time, it is better to put it back in a bottle and store it.
  6. QWhere should I place the 3D printer?

    It is recommended to place it in a well-ventilated, out-of-sunlight location.

    And it is recommended to place it stably so that the desk or table does not shake when placed.
facebook instagram youtube
About Us
We like to create specialized materials.
by Graphy Inc
Contact Info.

6th floor, 225, Gasan digital 1-ro, Geumcheon-gu, Seoul, Republic of Korea (postal code: 08501)

T: +82-2-864-3056
F: +82-2-864-3057

Company Registration No. : 848-88-00661

Do you need any academic or clinical references about our materials?

Log In   Sign Up